I try the map maf limiter (temp)

[pinotec]

Hi to all
as the title suggests I try the above map of a 406hdi 100cv ,
could this be the address 06583A of the attached file ?



http://www.professionalchiptuning.ne...9&d=1340027111

[jolidj]

ao never done it, and 2 you can both .

here you go my friend 6639e + 66440 + 2 others similar in the area of the maps. the maximum nr on the map refers to the maximum speed and minimum temperature .
namely, for example, 5000 rpm, the a-20g you have 44.37 mg nn if I'm wrong. I so l-I translated and then maybe nn cio understood na bat .
let us know how it goes.

[michell]

Hi to all
as the title suggests I try the above map of a 406hdi 100cv ,
could this be the address 06583A of the attached file ?



http://www.professionalchiptuning.ne...9&d=1340027111

I'm sorry, what would this map????? ? a curiosity my

[jolidj]

limiter mass area sucked . limiter maf .

[michell]

limiter mass area sucked . limiter maf .

ok I have heard of, but I do not sn never served honestly ,as ever you have to get them to limit ???

[pinotec]

ao never done it, and 2 you can both .

here you go my friend 6639e + 66440 + 2 others similar in the area of the maps. the maximum nr on the map refers to the maximum speed and minimum temperature .
namely, for example, 5000 rpm, the a-20g you have 44.37 mg nn if I'm wrong. I so l-I translated and then maybe nn cio understood na bat .
let us know how it goes.

thx bro
but it's not what I was looking for :-P
the map that I should always express number of turns and degrees in the axis ,but then and expressed in g/s (at least on edc15p)
while those posted by you are the famous maps in the jargon called "hot start" that you played perfectly...

[jolidj]

for me the sn ones , tap try them if no nn if it comes out.

[munro]

ok I have heard of, but I do not sn never served honestly ,as ever you have to get them to limit ???

if you ever take? remove the limitation....
I rescale the position breakpoint for diesel....

[jolidj]

in fact, the map limits , we eliminate by changing the limitation ... if no change to make