Opinion the map ALFA 159 1.9 JTDM 16V 150CV

[infinitedestiny]

Hello all,
on my car I loaded the map in the annex, which is not being done by a professional, in my opinion, has gaps.
I am sure that between you, c'? people more? expert to me... according to you com'? made? You can? to do better?

There? that would interest me are of the fixes that allow me to:

- do not give problems to the DPF
- close the EGR valve
- responsiveness at low revs, with the original map from 1200 to 2200 rpm c'? nothing
- performance is slightly higher (but I'm not interested in speed? toe, I just wish that it were elastic)

Obviously, within the limits of the possible and the reliability.


Alfa romeo 159 1.9 JTDM 16V 150CV
HWSW: 144-871

Grazieeeeee...

[giarras]

please, before you may move on to the presentations so? we know each other a little...anyway, you are welcome.

[infinitedestiny]

Oh sorry, I do it immediately...

[magi1984]

the map does not ? evil, maybe ? to get better but I have seen really worse.

c'? only an error quite coarse on the turbo pressure, i.e. you have changed the rev limiter.
your turbo pressure gets to 2570mbar, but the limiter ? set to 2500mbar

[blackwolf76]

that car does not ? gaps in the delivery, maybe you have some fault ****llo mechanical type egr dirty.

[msport (exil77grande)]

that car does not ? gaps in the delivery, maybe you have some fault ****llo mechanical type egr dirty.

guys but have you seen the map? perhaps you are joking right?
maybe I see them only I increases in the negative on all of the maps in the driver's wish, and the rest, without sense,maybe I see them only I completely increments the data on the injection phase,the torque limiter from 55 to 200%,you have seen that you are completely advances? 200 points on the time of an overboost? have you seen the table on the rail pressure?
look at the dl write that is not a map malvaggia it seems to me really esagertao.

[giarras]

I msport, there are increases in the negative, and the various increments are differents..my advice take it from 0 and gradually, beginning with the different maps, that the suggestions will come up.

[fa2st]

how do you remove the increases in the negative if we are already in the original file? identifies, in 2d? or are the ones in the table are"xx"?? thanks a lot guys!

[msport (exil77grande)]

how do you remove the increases in the negative if we are already in the original file? identifies, in 2d? or are the ones in the table are"xx"?? thanks a lot guys!

then loading the sw ori and mod scroll in 2d with the button that takes you from one change to another, and so see those increases in the negative,then select with the cursor the affected area and click on the button to make the area that the ori.

[jolidj]

I think that is due to the way of change in 2d. if you edit in the table do not have these types of problems , at least nn that are due.