change advances

[munro]

give up your mind ? too convoluted.....I recommend a specialist......but from a vet?.....you're two horse-crazy!!!

[Chris156]

no one who understands my examples??????? hehehehe..

then you explain it better.. the fuel starts to burn at a specific pressure in the cylinder.. in original condition reflects what is established by the manufacturer..
for example, to 4000 rpm with tot prex rail and tot bar of turbo, etc ..all this make? so that, for example, 5 degrees before tdc starts the combustion..
The thing that you need to understand about the examples that I have done (raise the head - child that inflates the balloon)? this!!!
Now there 6?

[cicciogsr]

and ends thirty degrees in the morning?

[Chris156]

nooo...

[cicciogsr]

the file that I posted I the injection lasts 30? to 70 sq mm and the advance ? of 20 degrees for the same amount?.. eye 30 to which I am not ? advance..

[megamind]

a degree in ir? means the 5% increase?
and in that point of the map have given it?on the whole map, or only at high rpm?just to see

Watch I am attaching the screenshot cos? it is easy to understand.
Are 2? in relation to the values that I have on my table + 6,48%.
But them I stopped because? I saw that the limiter of the advance ? set to 40?.
Then, having made a slight modification I would not. remained in tolerance
Even if ? very little I felt the car the most? the nervous system, and even more? noisy.
The increases I always try to follow the original in a progressive way.
I put a screen of winols of the ori why? the axes on the ecm are wrong.

[cicciogsr]

the two degrees on the basis of what you have calculated?

[Chris156]

take care to give degrees to.....

[megamind]

I have not done that calculation, I lifted the times up to 7%, and knowing that the limiter is at 40 degrees I raised the advances. Following the ori. But I am the beginning and I did this test because I think that when you do a mod. Increases or decreases in all of the maps that are in the report. For me it is difficult to think that the person who made the original map I did wrong. Then I try to raise following the set in the set where I need it.

[cicciogsr]

I have not done that calculation, I lifted the times up to 7%, and knowing that the limiter is at 40 degrees I raised the advances. Following the ori. But I am the beginning and I did this test because I think that when you do a mod. Increases or decreases in all of the maps that are in the report. For me it is difficult to think that the person who made the original map I did wrong. Then I try to raise following the set in the set where I need it.

as the beginning of v? well to understand how it all works.. and according to me, you'll realize that the advance arrived at a certain point, you do not need to touch it..