Council map Audi A3 2.0 TDI 140cv

[Gianpy80]

Hello guys.. just joined and already? I'm asking for advice on a map that I st? by becoming a fool for quite a while..
This is an Audi A3 2.0 TDI quattro with SW 1037390138. On the machine we installed a turbine hybrid slightly more? big as the original, and on the bearings. We have also deleted the EGR and KAT but I can push this machine as it should. Also I was not able to delete the EGR from the map it with ecusafe it in the manual. mistake in the address? Initially off, then after about forty miles, you turn the light engine
I'll post the map ori and the last mod I did.. give Me some advice on where I'm wrong or if I got it all wrong

[Gianpy80]

anyone?
precise that I don't want to make the map.. I have also posted my mod.. I just want someone to explain to me where and how I have to go to act to make better the turbine that we have assembled, and as an individual area of the EGR..

[msport (exil77grande)]

anyone?
precise that I don't want to make the map.. I have also posted my mod.. I just want someone to explain to me where and how I have to go to act to make better the turbine that we have assembled, and as an individual area of the EGR..

tomorrow I'll take a look and tell you.

[Gianpy80]

tomorrow I'll take a look and tell you.

Thanksss

[msport (exil77grande)]

hello,I just had a look at the map,then I don't know if there turns with the map, or if you have tried but I tell you not to try it or to remove it immediately why do some serious damage here is not about some kind of error but it is all completely wrong and changed tremendously and I'm saying,also the torque limiters are also mmostruoi but in the negative, I repeat like a brother to return it immediately ori and talk to a professional because no offense this map is made by those who do not understand, for nothing.

[Gianpy80]

I know that I have zipped the mod wrong.. I did so many tests... Tonight I turn on the laptop and place that is currently loaded. However, leaving aside that this is only a test (limiters knew it, but don't ask me why? but in the negative were best, then I have them reset ori) about what percentage I could push on in. Prov. and press turbo? I have to say that not so? idiots., of the machines I have
mapped but this part of the turbine, a different gi? from new not ? never went well..

[magi1984]

I think it is better that you post the correct file before to give you any opinion or advice on the mapping

[msport (exil77grande)]

I understand that you have done many tests but I do not understand that the test would be to decrease of up to 100% of the torque limiter or increasing something like 4600 points, the pressure of the turbo,however, e-mail, to the present, we see them as you put it.

[Gianpy80]

4600 points? no, there must be a misunderstanding.. maybe 460.. I have used the ecm 2001. The question of the torque limiters don't ask me why? but it seemed to work to the contrary, that's why? in this map, I had them lowered..

[msport (exil77grande)]

4600 points? no, there must be a misunderstanding.. maybe 460.. I have used the ecm 2001. The question of the torque limiters don't ask me why? but it seemed to work to the contrary, that's why? in this map, I had them lowered..

watch right from your friend that map to an immediate stop.