closing the egr on edc 15

[goku]

after various tests, maybe and I say maybe I managed to find the map to close the egr out of the driver..I ask the more experienced if it is actually closed or not,the addresses are different from all the ones I found in the various guides,for this I am a bit puzzled..I also ask for opinion on the rest of the map thanks to all

[goku]

...no one can tell me if it was done well,,,? ( damn auto-corrector)..

[elettro72]

to close the egr on the edc 15 just raise all the values to the maximum, i.e. if you es.12740,ports all 12740,in the ecm egr is called the injection phase-I put a photo of a good egr.jpg

[goku]

If you read well you will see that the map and out of the driver.. Then the map phase injection.. I do not see it.. I have worked in 2D..

[elettro72]

sorry goku map egr should be placed on your file 796DE ,ports all 12740, and you are affixed bravo 212-928. jpg

[goku]

..should be what I did,but not having the table not found...can you tell me what the values in the various maps..??

[elettro72]

since I can not download, I do not see what you have done,as I said, it should be closed,for comferma attacks the diagnosis ? are you sure you.........

[goku]

.. I just wanted to be sure before map l ECU.. I don't want to damage it ... Maybe I brought up without knowing the turbine 2 bar...

[msport (exil77grande)]

then I looked at the file,the egr valve and it was done well as the only method that you need to bring the maximum value to 12740 you on the other hand you are stopped at 12730,for the mapp I would say that can go as edit soft without great pretensions, and you should double-check the beginning of the map that ecm calls injection zoned because there is a little mess right at the beginning,also if you find the machine that turns off suddenly pulling 3-4marcia or about 180kmh a low of 1-2%, the pressure in the rail,I saw that the the last curve and' ori but maybe you did it on purpose.

[goku]

then I looked at the file,the egr valve and it was done well as the only method that you need to bring the maximum value to 12740 you on the other hand you are stopped at 12730,for the mapp I would say that can go as edit soft without great pretensions, and you should double-check the beginning of the map that ecm calls injection zoned because there is a little mess right at the beginning,also if you find the machine that turns off suddenly pulling 3-4marcia or about 180kmh a low of 1-2%, the pressure in the rail,I saw that the the last curve and' ori but maybe you did it on purpose.

.. Thank you very much, tomorrow am ..if I can't find the,the mess will continue? to break the boxes...