edit elm 327

[giarras]

how to modify elm327 that f? whims can

for the pass contact in pm to the admin msport

[barchetta]

Good morning, ? the same aregomento that I would like to treat ioo , purtroppocome new writing I do not have the privileges to read the file RAR.
In particular, I bought a elm 327 but I can not figure out where it must be inserted to read idati of my ecu iaw 4wf magneti marelli ,
kindly who I puoindicare indicate on which pin of the centrelina to be entered in the contacts ?
thanks in advance
Fulvio

[bernardo943]

but ? a software or hardware modification to do the jumpers and the elm ???

[antonioantonio]

but ? a software or hardware modification to do the jumpers and the elm ???

This is a change in hardware. You must first remove the corrosion resistance of 100 ohms between pin 6 and pin 14, then you must connect both pin 6 and the pin 14 to ground through a resistance of 100 ohms and a capacitor of 560 picofarad in the series. (see attached diagram)

[bernardo943]

This is a change in hardware. You must first remove the corrosion resistance of 100 ohms between pin 6 and pin 14, then you must connect both pin 6 and the pin 14 to ground through a resistance of 100 ohms and a capacitor of 560 picofarad in the series. (see attached diagram)

thanks a lot but if I can't find the capacitor 560 pf the can I take more? great or pi? small ?

[barchetta]

The capacitors in general have an average tolerance that ranges from 5% to 10% , now I can't remember well in the business standard sold for the ability? in pf, but you can always put in parallel with a 470 pf with a 100 pf.

[barchetta]

I apologize nuovamene why? the system tells me that I do not have the privileges to view the jpg file ? I have not earn credits?
thanks
Fulvio

[barchetta]

again I ask excuse not riusendo to open the images, I go for the idea : pins 6 and 14 must go connected together and in turn ill all be connected to ground through a resistor 100 hom and a capacitor 560 pf which are parallel between them, right ?

[msport (exil77grande)]

I apologize nuovamene why? the system tells me that I do not have the privileges to view the jpg file ? I have not earn credits?
thanks
Fulvio

I invite you to read the rules, thanks.

[barchetta]

Regulation read, thanks msporteven if I feel a little restrictive, but anyway I adapt myself.

Return to the edit ,excuse of' my ottusit? dear antonioantonior, then regardless whether the pin 6, pin 14 should be everyone for themselves places in mass by putting in series to each of them, the resistance and the capacitor in series, I'm sorry, but by doing so the output can (not having yet open the interface rimarrenne connected to pin 6 or pin14 ?