hello, somewhere I read that you just need to put a file on the eprom 27c512, for about 30 seconds, and replace the eprom oricinale, and the immo is off, ? can?of course, no welding etc?thanks
hello, somewhere I read that you just need to put a file on the eprom 27c512, for about 30 seconds, and replace the eprom oricinale, and the immo is off, ? can?of course, no welding etc?thanks
No, you need to write the file scodifica on a 27c512 from scratch, and then desolder the mem. the original and solder the driver, and then perform the procedure ? pi? or less as you say. But in any case it takes the file scodifica.
I for quelel units use the decoder 7 ------------, is the 8F - 16F - 18F without problems.
just ground pin of the micro-and upload the file, it does it all the interface and not dissaldi nothing.
the interface ? definitely a stuff to the chinese, and if you search the web you will find dozens of similar
Last edited by msport (exil77grande); 13-11-2012 at 14:43
[COLOR="#0000FF"][CENTER][B]In life you never stop learning![/B][/CENTER][/COLOR]
[CENTER][COLOR="#FF0000"][B]I do Not answer to private messages with requests for help! If you need a hand, ASK ON the FORUM!!![/B][/COLOR][/CENTER]
Yes, with the tool affixed to it, to? you can? make the file....
ok, but the file scodifica ? the one that someone put here on the forum, where you talk to the immo?Originally Written by egs
certain units have the socket, and then you remove the eprom and moves without the use of welding if I'm not mistaken!!!!
sorry, but the name of the interface you can know?
Some have the socket, and not welding anything. Regarding the file, I have mine, even if I have a tool licensed and the original, the one referred to by the magi I do not know, for? if you are looking for on the internet (as he says), you'll find him...
? I wrote in my post... DECODER 7
[COLOR="#0000FF"][CENTER][B]In life you never stop learning![/B][/CENTER][/COLOR]
[CENTER][COLOR="#FF0000"][B]I do Not answer to private messages with requests for help! If you need a hand, ASK ON the FORUM!!![/B][/COLOR][/CENTER]
ok, I try to search !!!thanks..
I was going to find, but I honestly do not understand where you know the price!!
Write permission
Quote