Motor torque!how to interpret it on ecm titanium?

[megamind]

Complete the response to the munro:
The prex. the rail on my car has 5 maps (for each c'? the relative table)
A pressure limiter (in the bar) I was wrong to write atm bar being a single map
A target map (I think so you call it) that defines the goal.

If the target map is not changed even if I raised the pressure of the rail and its limiter,
the pressure cannot exceed the goal (and as if it were a limiter to chase but not to exceed)

I attach a screen made the mod. logged in on the diagnosis. I moddato the rail to 1660 and moved the target to 1660, and the limiters...result in the diagnosis 1660.
The pressure follows the target and reaches the limit.

[megamind]

Maybe a problem...yesterday evening I was particularly tired, anyway. thanks

[alfetta80]

hello munro I don't know how to thank you, and it was very important to speak with you, you won't believe this but I understood a lot of things in a more' even if the road is long but as with all things, you must first do the basics,now thanking god, or much to make off and I can't do it I can just go forward on edc16c8, and then you can post the news thanks again.......

[alfetta80]

munro you have done so much, and how.!!..
now I would like to ask another thing,when it comes always with titanium the edc16c8 or the c39 and the other, I find myself listing of resources-axis im 2d, for example, rail pressure rpm rpm then the quantity of fuel injected for rpm and to the side, or the increase in to do bar in ie and did it very well, but when it comes to, for example, a golf4 edc15p 101cv with titanium I am all of the maps in rpm and load, and just,munro you told me not to listen to what he writes ecm but to follow the axes on the edc16c8 39 etc ok but on this that it's all in rpm and load as you think......thanks..

[alfetta80]

hello munro then let's see if I understood it!!
then you said that the load, i.e. the load on the engine and is a measure taken depending on a given parameter,taking for example the pressure turbo I find 3000 rpm at 100% load and the z-axis, find the year 2000, which would be the value given by the pressure sensor and that raising the air pressure 1bar right??then it is the value given by the pressure sensor according to the number of turns???thanks

[alfetta80]

what do you mean by only one percentage of the load??
in 2d the same or the rpm and load on the z-axis, there are no measuring,I only numbers from 0 to 65,000, and on the other maps, and diesel the same thing....

[alfetta80]

the map and' enrichment and acceleration, which in fact should be the pedal??but excuse my ignorance but could you explain to me the precise definition of IQ??the screen as soon as I can the place now I'm still at work...
anyway, the axes in the maps are all as described not only the DW

[alfetta80]

munro, forgive me!!I do not send to that country, but I can't post the screen how do I do that??

[alfetta80]

ok we are done here is the screen...

[megamind]

ok, take a look at the map the pedal shown in the table,do not use the titanium because? I have a problem on your pc and then use a sw free that still has all the same features,as you can see in the image you have listing of resources axis X pedal; Y rpm; while the Z-axis, and the IQ in mg/str...if, for example, go to the column on the 100% pedal you will notice for the same percentage of a quantity?...in 2d it works exactly?....

Sorry for interrupting, sw. ? this that uses it?