Error p2563 after upgrade turbine 1244vz vs 1549vz

[gabrielikkiu]

Hi all, I have replaced the turbine, the original with that of gtd, but just put in motion by placing the gears gives me error p2563 and light the glow plugs turned on , I tried a little while ago, starting a little more cheerful first and second, and to me , what can it be? Screenshot_2020-05-29-10-15-09-050_org.prowl.torque.jpg

[micheleyr6]

the actuator is giometria variable are ok??
if it is probable that you have to change the maps management turbo because it is the biggest and the most lag is the ecu you get error

[gabrielikkiu]

Watch the turbine is new so I suppose they are new anke the other components ... In any case, the way in which you change? The problem is that it does after a short time even at idle ...just salt little bit of temperature by placing the gear and pin ...light the glow plugs

[cinqueturbo]

Hi all, I have replaced the turbine, the original with that of gtd, but just put in motion by placing the gears gives me error p2563 and light the glow plugs turned on , I tried a little while ago, starting a little more cheerful first and second, and to me , what can it be? Screenshot_2020-05-29-10-15-09-050_org.prowl.torque.jpg

She says in the clear and out-of-range the position sensor..
or align the sensor the last I see.. or you align the map..

[gabrielikkiu]

She says in the clear and out-of-range the position sensor..
or align the sensor the last I see.. or you align the map..

Thanks ... The problem apparently is to align the map to the sensor ������