Luca stanca Lancia ypsilon 75hp

[alex210392]

I recommend that you reset all of the parameters with respect to the FAP.. also the degradation of the oil, and then write the file..

It is, in fact, otherwise you will have trouble in the future, especially a break write and rewrite the file that takes 45 min if I remember correctly

[cinqueturbo]

I hope for you that you remember bad..
and to read of time it takes for your instrument 24h?

[alex210392]

I hope for you that you remember bad..
and to read of time it takes for your instrument 24h?

a good hour.... and I read in BDM and immediately the stool, while to read my opel corsa and the other was a lancia y, both 70 hp ranged from 30 to 35 min to read and 5 minutes to write, whereas on a peugeot 307 1.4 hdi (bosch) less than 2 min to read it

[alex210392]

Here I am, the map is loaded, the key on the light is flashing instead of being lit for 2 seconds as before, but just set in motion stays on and will appear on the display of the instrument panel the error clogging particle

[cinqueturbo]

Then??
you have made the adjustments, and reset before writing the file?
Now what are you going to do?

[alex210392]

Then??
you have made the adjustments, and reset before writing the file?
Now what are you going to do?

I think you need to redo the entire procedure, ori of new, re-zeroing, write, file dpf off, I read that some 500 after 1000 miles, it gave the above error here, however, is instantaneous, however the car turns well even with the light on

[cinqueturbo]

My dear, but I'm file luca stanca that you did... now that I see it is normal that gives you trouble...

but if you needed a file ready just cambiavi approach and the title of the post...

Help DPF OFF + indicator Lamp Ignition to the key on...

only doubt for me is the 8AB2E pane the light.. due to the software itself of this Y..
And then I've prepared two files..

1 as you well understood, and loads the file Ori, put in motion, the Gates of the various faults etc
2 Reset all parameters.. but everything.. is also replacing the DPF, Degradation of the oil, etc..
3 Loads the standard file... and if everything is ok... and want to try writing other things...

Next, you'll see that you don't have to program the ECU 5 times..

[cinqueturbo]

Oh, I forgot, when you do the reset, checks that are stored in the memory....

[alex210392]

Oh, I forgot, when you do the reset, checks that are stored in the memory....

thanks again for the support, the five, now my friend is away on business when he returns and has a free day, I make everything as described by you and try again.
Thanks again very kind

[sportknight]

these are the do it safely with dpf remover demo,I'm not even docuti adaptations,shot the file in and via