good evening,
I have to read a BOSCH EDC16 C39 0281 012 193 processor-MPC-562m but I have the protocols of my tool who read the versions with the MPC 555 and 556. Seen attacks where to solder are the same, I might try to read it using the mentioned protocols? Has anyone ever tried it? Risk cooking the ECU or just failure to connect.
Thanks
edc16 bdm are all the same...
that the also read from the socket with the tools and more common.
Attention that many Iveco reads only a part of the table flash in the obd,and you risk modifying and rewriting have problems after because it changed in the middle', yet you have to make a complete reading to tour and then write to a file full BDM readed by obd, to ensure they write all the zones tables..Originally Written by blackwolf76
Thanks,
I have connected the bdm, and actually recognized the protocol, even if it appeared not on the ones available. Read and wrote regularly.
Quote
