good morning
I had already asked for info with the discussion in section the equipment to program the ECU, but I have seen it a few visits and no answer. Sorry (who has already read it) if I insist but.......

I can not write correctly the 2 PLCC32 ECU BOSCH for my car. I read the original files in the united states with the ECM, changed the map, made the checksum regularly, split the file in 2 8-bit and when I go to re-write it with programmer TL866, the writing takes place regularly but the car is not starting.
I was told that the file must be cut before programming the AM29F010B but I don't know how to do it. In practice, the program would fill the empty space of the chip over the 128 kb of the map.
I think it's set on the programmer, but I have no idea of the procedure.
It's so ?
Who can help me?