problem smart 600

[carfree]

good evening to all , I wanted to ask you for help on a problem I've experienced on a smart 600 practically off the turbine, and walk sucked.
I replaced the solenoid valve, tubes, and sensor turbocharger but the anomaly is the same.
in the diagnosis ( delphi ) leads me pressure turbocharger .. gate the error, and for the first metre falls in the work after a little redeems the recovery and ca walks sucked but the turbine whistles, then it would seem that, however, does not fall off of everything, what do you think ?

[Andrea1]

You've already checked the auction, which manages the wastgate?

[carfree]

You've already checked the auction, which manages the wastgate?

Hello, I only now saw your message I had tried to see if it was back and forth with the hand, and seems to be all set in any case how could I check?better ?

[Andrea1]

Check the set screw that there is on the rod sometimes come loose and cause problems.

[carfree]

ok thanks a lot I will check hope that will be the fault of faro know how I fixed it in any case .. have a good day

[saetta]

the tubes that are on the valve pierburg are in the right place? are intact?

[carfree]

the tubes that are on the valve pierburg are in the right place? are intact?

Certain that they are intact, if you read carefully what I had written.
I had written that I sostiutiti!
Anyway, I solved by changing the wastegate valve .
That was the route the diaphragm tanks on the inside.
Thanks anyway to all .

[saetta]

Ok, thanks for the sharing the solution of the problem

[carfree]

And nothing is right as it opens it closes a post .
On to the next .