MARELLI MJET impariamola!

[Backgroop]

Hello to create the rev limiter the maps in question, or, rather, the limiters are before map injection

[puntospeed1.3]

hello as you moddato bit? 213 the have brought it up to 900?

Put 250.. all ok tried up to 1600bar

[enrico pontoni]

The trovu to 6000...

thanks jack

[enrico pontoni]

Put 250.. all ok tried up to 1600bar

hmm I find lots of bits with this value -.-" more or less is near to the map the pedal?

[enrico pontoni]

Hello to create the rev limiter the maps in question, or, rather, the limiters are before map injection

thanks now I try to search

[enrico pontoni]

Hello to create the rev limiter the maps in question, or, rather, the limiters are before map injection

ok, l I have found after two-bit they do : the 175 and 125. set to 4300 but not funzioniona. after the 4300 there are a couple of bits to 00000, and then the map main inj. I set wrong something else?

[Danny]

There is only a single bit set to 6000 before the time of injection...One, and only one , single, a mind of its own xD

[enrico pontoni]

Hello to create the rev limiter the maps in question, or, rather, the limiters are before map injection

ok, now the rev limiter works as it should at 4453 rpm. only that I turn on the mil and gives me error p0219 engine overspeed condition

[enrico pontoni]

There is only a single bit set to 6000 before the time of injection...One, and only one , single, a mind of its own xD

thanks danny as I wrote below works now, but it turns on in recovery and gives me error p0219 -.-

[Danny]

You have done something wrong...