hi all I know that is a controller of a walk but I have to make a scodifica
with the rooster there, and the schema, pin out, but I don't know which protocol to use if what you are telling me in the car-fiat --iaw
or in some section tool bootg
qualkuno could help me in this thanks in advance to all
Hello I go to memory because it is a bit' that I no longer use the cock into boot mode, however, go to select the driver to use and select tools boot\ tools boot mode then st10f and select the driver st10f168 then make the connections and do the id and reading... for scodificare your iaw you have to change the eprom 95160.
Let me know if you can scodificarla because I have a two iaw in the home that I scodificato but I could still try them to see if the scodifica is correct.
Oh I forgot, not all of the gauls manage to make it to the tour, unfortunately, some fail :/
I know of the fact that some people can't but I have to do good without the risk that a customer fevo buy a programmatpre
I had a rooster that I did not read but just make sure you solder and are not likely if you do it well if not it just does not connect, the you should burn.
I visro that c' is also a tool for scodifica and clone to the ecu but I don't think the face in total and I read that in the ultomo passage when he says of xlonare you have to put cancel altromenti begins to clear and goes in block bhooooo
Now I can't remember the functioning of this tool, because I'm never riusito to read it with the cock.Originally Written by tac89
In 95160 there is only the immo? And the parameters of the engine management where to find them?
No in 95160 in addition to the immo there are other things, such as odometer and the other, the motor parameters found in the micro.
I remember having scodificata a reading l eprom with a programmer upa and changing of the strings found in the internal and it worked...however, turned on the light code. On a car of a friend, I have a unit that is equal scodifica but without the light on. I would love to read it to understand the differences. If you need the strings that I used let me know that I try
If tac89 was able to read the ecu you could try to process the file with the meucci that in theory should work.. but I'm not sure why some say it functions, others the contrary, then we would have to try and remove the doubt.
I had tried to load the file (always scodifica partial) with different software in the hope that they work in a similar way but I have been returned file is always different from the sw to the sw.
Quote
