Mjd8f2 file 2049kb or 2048 kb

[Errecinque]

I also write here saw the post opened by me.

Regarding the marelli mjd8 confirm (I just tried I on a file) that if we have a backup in j-tag from 2049kb cut it with the ecm to the address 1FFFFF, and we will have a file to 2048kb ready to write serial

[ugoboss]

hello, errecinque you can put a photo of the ecu, thanks.

[Errecinque]

hello, errecinque you can put a photo of the ecu, thanks.

Hi ugo I have the car in hand you will now place the data.
Hw MJ8DFHW00A
SW 9754B187
VER.SW 0087
SPARE 51896812
VER HW 00

[Errecinque]

Those with kess...and cock giving me
51896812
MJ8DFHW00A
9754B187
8F2.B1H.
0B B1 0719
.8F2.B1...

[ugoboss]

the sw is different from what I have read on the serial line I, the mine was 9754B287, in any case, I don't understand why you can't read it in the serial.

[Errecinque]

the sw is different from what I have read on the serial line I, the mine was 9754B287, in any case, I don't understand why you can't read it in the serial.

Watch...in a week we tried again because it is already mapped and I wanted to pull out the file that is there currently and then the cock is not for my case. I understand that I will have to do a reading in approximately 2 hours...if my kess connects (they have also advised me to change the speed and set it to the minimum) . I know.thanks

[ugoboss]

then the hole in the k-line and you will see that it connects, reads the injectors (not as you say that it reads them only in the can) and then re-enter always (k) to read it takes a while, I don't remember how much, but more than an hour, it is very first, put in a battery to support the machine and the laptop attached to the power supply, and you'll see that everything goes right.