to make a complete map

[skizzo93]

hello guys,I would like to make a mappetta that is accurate enough to squeeze my car(alfa gt 1.9 150cv with downpipe,center silencer sports,final, muted sport,bmc air filter,reinforced clutch with a flywheel which is lightened).
I bought time ago a map by a so-called remapper online, but the map also if it goes well enough, it's not ideal as many who have viewed have said to me for what I was looking for.
my goal was to make a map, that would give me a way to take advantage of the stuff I ride and squeeze the turbine the original before the next step, or turbo plus IC on the front(tubes IC aluminum them montero in the short term. Speaking with many rimappatori and preparatory, with turbo of the series, without sbragarlo in a long time, have told me that they can get increases of 40\45cv and 70\80nm of torque. Sincerely, I say to you that I would not like, SINCE WHEN IS it POSSIBLE to throw the file purchased, but trying to improve it. I hope that this discussion can be a good starting point for many.

Let's talk about a edc16c39 HW 0281012883 SW 1037379006.

I enclose my file ori + map purchased + a small review done by me. The thing that maybe by the first of the eye(in my review) is the map of the geometry is decreased;the change I made for not to piccare the turbine before I piccava also at 1,850 by marcie high. now stop 1.6, gradually descending to 1.5\1.450 bar. I hope that the discussion will be followed by many users, so as to make unabella is also a guide for all those wishing to get their hands on so much widespread edc16c39 mounted on the many jtd in circulation.
gt ori my 2.rar
mod acquistata.rar
before revisione.rar
Thanks a lot to all.

[passione motori]

Hello, if you are not happy or satisfied with the remap of your car, speak with your supplier of the file, too many around you do call in the professionals and take out the horses to the loads, remember that the car is your and you also need to know what degree of reliability you decide you have................

[tranky]

Hello Skizzo93,
I am sorry not to be able to help but I am a user/utonto and I still can't download attachments..
I advise you to see the other post here, this site saw that on edc16c39 there are (I think.. since I have not enable to download I don't speak for certain) that many of you have moddato the unit with considerable info described, and files shared.
The GoodLife!

[mecdoc]

With pressure at 1,6 unfortunately you can't squeeze too much

[Fabiuz]

I gave him an eye, even if you are past 2 years, and perhaps no longer have this car.
There are 2 things that make me smile even if I checked the right spots.
Speed limit from 299 to 350Kmh??? What would be his signature, I'm a guru?
And in the amount of fuel injected lifted on the bottom of the stairs broth, with the percentage negligible -0,2% and -0,1%.....
Them usually from above for a +5% increase not a decrease.
Some maps have risen without the policy, and in a mathematical way, rettangolone in tabular from 30% load and 1000rpm ALL 5% or 10%
Then no one will correct the map for free, but an opinion you can give....
This will go down in history as the one that was diesel but up to 100 per hour the speed limiter.......
Those are things that are example on the 118D that have the limiter at 210Km/h and gets up to 260 x unlock it, and then pass the 210 just... Are limiters that puts bmw to not go to the maximum speed a 118 as a 120....