The map informed delta 1.6 mjt

[tranky]

let me know what you think of the mod that I found and edited in the map that I don't know if they serve and limit you the iq but I assume it is correct, change them so, the same with the limiters on gear

[giuseppe89]

Nothing to do always limit to 71 mm3, more or less, however, as the torque delivery at low revs and improved,by tapping on the limiters pushes better around 2000 rpm and then get lost...I know that that if I don't log mes do not understand much. After I try to mount it on a virtual machine if no I have never done such a thing

[tranky]

Nothing to do always limit to 71 mm3, more or less, however, as the torque delivery at low revs and improved,by tapping on the limiters pushes better around 2000 rpm and then get lost...I know that that if I don't log mes do not understand much. After I try to mount it on a virtual machine if no I have never done such a thing

MES runs well on windows evolved.. install on windows that you have and go!
anyway, you said it well.. and computer.. I'll write how to do it virtual!
Simplified procedure:
Install first the driver of the ELM connected to the USB on the PC (the Physical Windows10, or that which is)
Check on "device manager" if you give "CP2101 USB to UART Bridge Controller (COMx)" or similar
If the from and it works, install ESM on the Virtual and insatalli the vmware-tools and the drivers of the MES
At this point, the virtual window you need to share the USB device
Done this everything should work..
I do not guarantee the stability and the integrity of the log that might generate, but better than this with winzozzo nse while ago!
Let me know

[tranky]

ah, an oversight..
"CP2101 USB to UART Bridge Controller (COMx)" under "Ports (COM & LPT)" that appears when plughi (attacks) the usb from the "device manager" !

[giuseppe89]

I finish lunch and I'm going to try,mes, l I have installed time ago, and acts as, the elm had the problem of recognition of the ports or something similar I don't remember

[tranky]

if you port the question is on the "resource manager" as I said above..
Sect a com3, and do the same from the settings of the mes
I think that may solve so

[giuseppe89]

I finish lunch and I'm going to try,mes, l I have installed time ago, and acts as, the elm had the problem of recognition of the ports or something similar I don't remember

[giuseppe89]

Ok I will try

[giuseppe89]

Screenshot (17).jpgScreenshot (16).jpg tranky these are the screen of the problem I have,if I try to download a driver to me after a bit the error 10

[tranky]

You have to install the UART-to-USB or a name like that.. I don't remember.
If gugli, you'll find him