Hello guys,is some day to lights on, the stop the rear driver side does not work,as I turn off the lights back to work.
I disassembled the headlight,checked the lamp (which is good), clean the contacts,raised the slat below, but the problem remains.
Can you tell me where is the problem?
Thanks.
check that the bulb over which the good is suitable to the place where it is mounted, and that it is mounted well.
ugo ---- president A.E.P.
Hello Ugo,thanks for the response,this morning I double-checked everything,and I found the problem,it was the tab of the negative on the plastic connector open too much that was not making good contact.Originally Written by ugoboss
Hello and to the next.
usually when there is these problems are usually always the masses who do not make a good contact........
In fact, it was precisely the mass
You burn more of those slats, too much electrical load x their ability and in a little while you will do the same defect. I create a ground wire between the lamp holder and the body to resolve.
For now, signs of burning there are none, the problem was that in this connector.
Opss I correct myself,the Rear.
Quote
