elimination maf edc15-16 talk about it..

[rego88]

no no.... the ducato 2.8 jtd.... if you tell me who has not the air mass meter.... I'm going to take the laptop and postro the file.... mounts to a edc15c7

[rego88]

I accelerated too much.... in the suitable section of c'? already files of the duchy.... but I think that they are good to take the opportunity to remove the meter..... anyway, where I open the post x the file that I made??? area offlimit???

[rego88]

yes, but also the duchy has the same engine but with electronic edc15c7..... it should be no meter also..... I was seeing and I found a couple of differences..... so much talk of a bit set to 0, and must be moved to 1.....

[rego88]

can I post here the file ori and mod that I suppose that is??? who has a damos or a2l a edc15c7???

[cicciogsr]

I s? that on the ecu of the vag c'? the possibility? to make the switch for? not s? as you f? and even in edc16 c'? well as a limitation of the diesel fuel based on the pressure measured... could also be a way to delete the deb...

rego do you by chance know how to delete the deb on the 105jtd?..

[msport (exil77grande)]

munro placed the screen

rego88 you if you have a sample file ori and mod tested that you want to share post it in a new post in the ecu section or diesel then I'll move into off-limits, so that it remains semi-invisible.

[rego88]

ok daniel.... I do it immediately.....

[rego88]

I s? that on the ecu of the vag c'? the possibility? to make the switch for? not s? as you f? and even in edc16 c'? well as a limitation of the diesel fuel based on the pressure measured... could also be a way to delete the deb...

rego do you by chance know how to delete the deb on the 105jtd?..

watch.... I did the same tests on the jtd105, but unfortunately fails..... does not work the same way.... if you disconnect the meter on the jtd100 or 115, it should be in the fixed value at 700mg... if I disconnect on edc16c39 or edc15c5 continue to walk.... but the thing that I understand... on the basis of x to calculate the intake air????

[rego88]

but what can I say ? this.... if you disconnect the maf on the edc15c7 ? much more rapid in increasing rpm the car but it smokes a bit... but the other 2 remain almost unchanged.... how to remain unchanged values.... on edc16 how do I then raise the value of the meter????

[msport (exil77grande)]

ok daniel.... I do it immediately.....

rego on the forum I'm msport (exil77grande) (admin)