Hello to all,
I have attached the map file which I was uploaded some time ago. The problem that presents itself is between 1500 and 2000 rpm with a dose of throttle low: the reaction is to have vibration of the car ( to understand each other seems a gasoline engine which is switched off, a cylinder, strattona), which disappear by releasing the accelerator or or increased.
Tired of this situation, I set out to do and I read the map with Mpps and then to open with ECM Titanium.
The maps that are changed compared to the golds are:
- injection zoned
- press turbo f(temp)
- torque limiter
- torque limiter 2
- torque limiter 3
Now because of my training in this field, I would say, close to the ground it seems to me to have understood that in the map, injection split and press turbo f(temp) there is something wrong; the map the EGR seems not to have been touched by what I see from the ECM, but I don't know what software was used in the beginning and then I don't even know if there are other maps that were changed that I can see.
The car has mounted panel filter Bmc and no longer has the dpf.
At my disposal I have the software: ECM Titanium 1.61 ECM 2001 6.3 and Mpps 16.1.0.2
The control unit has HW 0281017514 and SW 1037515044.
Thanks to those who I will want to give some suggestion.
it seems to me to have understood that in the map, injection split and press turbo f(temp) there is something wrong; the map the EGR seems not to have been touched by what I see from the ECM, but I don't know what software was used in the beginning and then I don't even know if there are other maps that were changed that I can see.
Quote
