Alfa 147 edc15c7 the injection times of doubt

[frenk85]

Inject 80 mm3 because of him you have given us through the maps the pedal and the lim couple.an idea that I have done?are the limiters for a possible upgrade,as are the limiters gear which are set all to 100.am I wrong?!?!

[Errecinque]

I looked a bit here on the forum and I found a couple of discussions in which they say that the edc15c7 list the values in mm3 I don't understand how it works 078efc is a straight line, at 6000 I would imagine that they are mm3 to turn it into mg would be about 70, but in the map I have now on the car is not modified I've made a log and 80mm3 them injects anyway, perhaps only in certain conditions..I don't know

If you don't do a map informed, well it is hard to trust the diagnosis. If you do not calculations well tinj with respect to the iq you like, I think that the mm3 at diagnosis are not exact, but here we need someone more experienced to confirm what I said

[DavideO]

Thanks guys!you're right, r5 I have done the calculation on the contrary! The time I calculated on the basis of the rail with the formula that I posted at the beginning that if I'm not mistaken I found in a discussion of munro! In fact, my goal was to learn how to make a map informed with the one I have, the turbine has peaks exaggerated and is not the value in the map, I guess that is because the ecu does not know truly what you inject..this I think I would not like to say nonsense

[aleg]

David, have you tried the map?

[DavideO]

Hi aleg!I rearranged a bit tomorrow if I advance a bit of time to load and I try to do a log! L I would have done it before but I had broken the flat that goes to the laptop's screen and I was without it!

[frenk85]

If you don't do a map informed, well it is hard to trust the diagnosis. If you do not calculations well tinj with respect to the iq you like, I think that the mm3 at diagnosis are not exact, but here we need someone more experienced to confirm what I said

are absolutely not an expert,but from tests I have seen on this ecu the iq you from across the maps the pedal.if forced (e.g. 80mm3)in the map,in the diagnosis of mi by 80 accurate then I don't know.........

[DavideO]

Tested today..should be less that the original impunta to 3500 rpm when you switch it off is strange as if you're working bad even the butterfly..the map is that I posted, and I fixed the bp of the torque limiter and I lifted those addresses data from frank up to 80mm3..I dunno maybe those addresses must not be touched or maybe not in that way..maybe I have not done in the correct way, the bp of the axes.. tomorrow them carry gold about everything and do another test!

[frenk85]

Post the map you entered

[DavideO]

ALPHA 80MM3 FROM COMPLETE 3.ZIP here frank this is the map that was wrong..today I tried to put ori those addresses and it seems to go even if not flying, according to me, mistake qls..

[frenk85]

hi davideO,I'm allowed to review a bit the map,not the I made on your map to play it quite a bit.