Hi,
I have this car with light Immo is flashing, I unsoldered the 24c02 and welded a 24c32 suitably planned, I lifted the pin 7 and I connected to pin 8, now the vehicle starts but does not accelerate over 3500giri.
According to You where is the problem ?
NOTE: THE ECU HAS NO PRESSURE SENSOR.
you need to program the injectors and the car goes ...
I don't think Alessio93 is an issue of coding the injectors seen that with the Kts-Bosch diagnosis, there is no such function.Originally Written by Alessio93
The car is a 1.9 DTI is not a 1.9 DCI.
it seems to me that them go cut a wire but I could not tell you which..
A rider does not create queues even in the car...
a automoblista create queues even on a motorcycle...
The wire 59 but should not be the same, I have already tried.
strange sure is not something else?
A rider does not create queues even in the car...
a automoblista create queues even on a motorcycle...
which errors have you in the diagnosis ?
In diagnosis I have found errors type problems eeprom....
Definitely scodifica not come to a good end, try this tested file, but written on the 24c16, the pin 59 just to have it cut only a problem, a minimum light engine on, and not the possibility of making the diagnosis, the rest ok
I wanted to make you aware of how much I have done.
I read the 24c02 the original and I put the file in immokiller and the scodificato.
Then I planned a 24c04WP I soldered the eeprom with the pin7 to be up and connected to the pin8 .
I cut the file 59 of the comb of the unit , connected everything but the car does not go beyond 3000 rpm.
In diagnosis, I find the following errors :
EEPROM or coding the wrong ecu
Clamping motor - Encoding incorrect
P.S.: I can NOT ATTACH THE FILES THAT I have READ AND PROGRAMMED IN the EEPROM, There IS A BLOCK FOR NEW USERS ?
Quote
