Delphi DCM3.7AP and Galletto 2 V53

[corrado]

edc16 and marelli 6f3 should be pi? easy to find,for example, if you find an old 1.3 mjtd of a point from a demoman goes well

hello Sportknight ,
today I was a demoman and told me to give me a ride and see if that was ... to the fact ? the point was not there , while machines I have found many but I didn't know to recognize a edc16 , above the ecu is not c was written edc16 , how do I know if one of those can? be good ?

Thanks !

[sportknight]

usually are cos? the edc16

EDC_16.JPG

and cos? the edc15

ECU-Bosch-EDC15-CDI-0-281-010-598.jpg

[sportknight]

the edc15 not have the fins on the case of usual..
above you have read written bosch,the siemens and delphi could go, but better if you try with the bosch ir? easy

[corrado]

[QUOTE=sportknight;66553]usually are cos? the edc16

EDC_16.JPG

and cos? the edc15

ECU-Bosch-EDC15-CDI-0-281-010-598.jpg
the edc 15 I see the image while the edc16 no ....
in the image of the edc 15 c'? just written , but in all the ones I have seen I do not wax wrote one and the other

[sportknight]

click on the blue writing

[corrado]

I have no messages are enough to open the image

[sportknight]

look for images on ******

[corrado]

look for images on ******

ok , I have seen them .... then those fins are all edc16 ( I bosch ) , right ?

Thanks

[159sportwagon]

Hello ,I have the cock v54 european. How do I get the update of 2013 . My and until November 2012.

[Marting]

have a look !