DPF removal EGR on the Alfa 159 2.4 JTDM

[ultimo000]

Many thanks.I feel at the end of the week.I must do the csf with ecuscan?before writing the file in the ecu with mpps,I have to give the checksum of the modified file in the ecm?

[munro]

both ecm mpps correct automatically the checksum...

[ultimo000]

Tube fap finally arrived. Is it okay if I proceed as follows:

1) load the file with the switch-ff as recommended from a friend errrcinque
2) can I change the mechanical part
3) changing the oil and resetto errors of waste oil with ecuscan

Should I do another?


Thanks

[Errecinque]

Tube fap finally arrived. Is it okay if I proceed as follows:

1) load the file with the switch-ff as recommended from a friend errrcinque
2) can I change the mechanical part
3) changing the oil and resetto errors of waste oil with ecuscan

Should I do another?


Thanks

I would say that it is all correct. When you enter the diagnosis after you have loaded the map controls the setting that is without dpf and clogging up to 1000%

[ultimo000]

Remap done.
Ecuscan tells me the filter is not clogged, and clogging up to 1000.
Everything should be ok.
Tomorrow I put the tube....will update on how it goes
Thanks

[zxrrr]

I learned thanks to the forum then it is fair to share to those who do not know. 1DE432 display 8-bit take it from 1 to 2 . 1e46ee in 16-bit carry from 400 to val max 65535. And the dpf is as if there were

Hello Errecinque, this speech is also good for the 159 1.9 jtdm 150 hp?

[Errecinque]

If euro 4 yes, the same discourse. The addresses may be different, but just comparing the areas in 2d the individuals easily

[zxrrr]

Thanks Errecinque! My first step will be to power off the electronic EGR since it is already broken, locked in closing, I cleaned but nothing has changed....then I will make the DPF

[Errecinque]

Thanks Errecinque! My first step will be to power off the electronic EGR since it is already broken, locked in closing, I cleaned but nothing has changed....then I will make the DPF

I think that if it has failed electrically you must also delete the dtc that you leave in a diagnosis after having disabled the usual procedure of panettone

[zxrrr]

I think that if it has failed electrically you must also delete the dtc that you leave in a diagnosis after having disabled the usual procedure of panettone

ok thanks for the tips....I...the operation I'm going to do with galletto1260 as an interface and a time ( my friend's) to process the file ori, I have read in the forum to work quietly on my ecu. As you may have understood, I am very beginner.