mapping tips and advice

[frenk85]

ko!
you see them and only that the ecm is not you for them "call" and are called out of the map,in order to see them you have to have eyes "trained"

[munro]

I'm sorry, munro I was making an argument on the basis of what you told me,correct me if I'm wrong.
you told me that the timing of the injection on this car in config golds are already sufficient to withstand a pressure of 1500 bar.
so according to what I know to let go of most of this diesel needs more amount of fuel and air of course.
now since the times are already enough to me it would be enough to raise only the pressure of the reasoning that I did is the following
with the same injection time if I increase the pressure I results in an increase of the injected quantity, is it right?
so let's say that the timing of injection should be increased only in the case in which the pressure with which I would like to work on a map are not sufficient?
if I increase the pressure open is also slightly time however would not be an increase in ****s performance?

you but the speech is a little more complex than this...
the ecu interpolates in continuzione the parameters in the map to give you unacerta iq...
now let's suppose that you retrieve from the map 65mm3 to 4000rpm ok?
the ecu what to do, and goes to interpolarsi in the map time(simplifying a lot but there are several other steps) to 65mm3 the press rail on the right and the injection time suitable to you to give you that date iq...
now if you increase the press rail, and notwithstanding that your pump rail is in great shape also taking the press at 1500 bar the ecu difficlmente will give you the pressure for iq, low or limited by the ecu itself..

[munro]

for frank85 hw and sw project are 928 212

[project]

ok, I'll have to still unlock on the blocks to continue successfully!
now it is only me sti cavoli blocks!and unlock it, and then get me a map to oc working on rail pressure and wanting to go up on the limiter smokes!
the times it would be better to leave them gold, you say?

[munro]

trusted with the clutch and disturbs ori's best to leave them ori the time...
make a test map to put it that I say then how to fix it and unlock it..

[frenk85]

thanks munro!
I took a quick look and I found(if I'm not mistaken) of the limit 07b270,07c54c,07fe02,iniez prov 07cd32,07cf58,lim rail 07edb8 for now.we see more in the.......

[munro]

then
07b270 is not a limited is the map request iq to the bosch engine
07c53c even he is a limiter and the map duty cycle of the pressure regulator rail
07fe02 is a map related to the glow plugs, do not touch it..
07cd32 are the injection times
07cf58 and the rail pressure request start-up
07edb8 is the limiter rail pressure as a function temperature diesel

[project]

ok I just put all the work is the load!

[frenk85]

I've done two on 6
o7f7fe

[munro]

some maps for you..
079abc pressure turbo
07bc22 iq limiter (10x1)
07bc5e iq limiter via fuel temp (6x6)
07d180 and 07d228 lim press turbo (1920), you can touch them if you want
07d2cc advances for the time being not to touch them
07fa74 lim press turbo function press atmospheric
07fbd0 iq limiter on iq (16x10) set it all up to 70mm3