MARELLI MJET impariamola!

[Errecinque]

same problem here... here we are again
the parity changes a point in the second series, the restyling has not given me problems in 1470 bar (1400 gold +5%)
on the race instead, that value blinks, a bit of time I set to 1450 bar and no problem
I do not think that they remain errors in diagnosis, it seems to be some limiter because the files of the two cars are not perfectly equal in all areas

To me it continues to flash even with maps, rail original. Can you give me a look at the file I posted above if you see some anomaly in the rest of the map that can give me that problem of blinking? Thanks

[Exelion1986]

with the map ori does the same? I have just a moment of time I try to see your file

[Errecinque]

with the map ori does the same? I have just a moment of time I try to see your file

Would you do me a big favor..***** and the rest you have already done previously. Thanks

[Andrea1]

Errecinque at the end you have managed to discover the cause of the light?

[Errecinque]

Errecinque at the end you have managed to discover the cause of the light?

The car is a friend, I always have it on hand but I have the head of a mule, and sooner or later I will discover the solution.

[Danny]

same problem here... here we are again
the parity changes a point in the second series, the restyling has not given me problems in 1470 bar (1400 gold +5%)
on the race instead, that value blinks, a bit of time I set to 1450 bar and no problem
I do not think that they remain errors in diagnosis, it seems to be some limiter because the files of the two cars are not perfectly equal in all areas

Normal, I very often happened that even with the same number of hw and sw, one was even if I asked 1500, it was restricted and amen, without having to turn on lights...other burned spies.

[Errecinque]

Normal, I very often happened that even with the same number of uhw and sw, one was even if I asked 1500, it was restricted and amen, without having to turn on lights...other burned spies.

Then you say that there is no solution?

[Andrea1]

cabbage but there will be a way to reset the ecu? even at the cost of eliminating the error in the map and then turn it back on.. in the end you have checked in the diagnoses the errors?

[franco-elettr]

faberecu which folder to map 3d I have to put your files for an upgrade?
thanks to the availability

[mate89]

Normal, I very often happened that even with the same number of hw and sw, one was even if I asked 1500, it was restricted and amen, without having to turn on lights...other burned spies.

but they should not be the same ecu with the same hw and same sw? that is, the produce in series and different from one another.