Marelli 6jf point 1.3 - ecu burnt

[gabrilupo]

does anyone know which tools you can use to align the try once replaced the various ecus?

[overbooster]

Now they almost do it all,you just have to have a diagnosis to be updated,what do you have?

[gabrilupo]

Now they almost do it all,you just have to have a diagnosis to be updated,what do you have?

I have the delphi has it as an option but always fails, it is possible to do it with ***********?

[overbooster]

it can also fail if there is any ecu that is not in line with the can line, if you go to the list of ecu you have errors? *********** perhaps the fa but I do not possess

[gabrilupo]

does anyone know if you can replace the body with a demoman? you can reschedule from the diagnosis or do I need to copy some of the memory??

[giary74]

does anyone know if you can replace the body with a demoman? you can reschedule from the diagnosis or do I need to copy some of the memory??

Yes, to a point a little bit of a walk I transplanted l eeprom. Now I don't remember, but if you need do a thorough research.

[gabrilupo]

if you have the opportunity to inform you I would be grateful

[giary74]

if you have the opportunity to inform you I would be grateful

Looking for a new body computer with the same serial, then replace the eeprom and the game is done.

[fuorigiri]

hi I don't understand why you have come to the body?

[Gia]

hi happened to me and something similar, of course, and good to give a controlled plant eletrrico I have not found anything abnormal in the system, I put an ecu and already a year and all goes well

It happened to me also very similar on a 6f3. The same mosfet, which in my case over the pressure regulator on the pump AP. After replacement of the mosfet and the capacitor, and broken down and has worked for a few days. When she returned I found the mosfet and capacitor, re-salted, and the scorch-through the pcb from side to side. I guess the problem came from the layer of the slopes that you are in the middle