Vw Golf IV-101 hp error 18062

[Rebound]

hello to all
I write, and why? they are now 3 days that you are unable to come to **** in this issue...
the car ? a golf IV 1.9 tdi 101cv
? arrived in the workshop with this problem in diagnosis: **** llo engine oil code 18062, the flashing indicator light engine oil
the light turns on not immediately but in the bike after a p? sometimes after 10 minutes sometimes immediately
the problem ? the car comes from a trader that has no idea of the operations performed on cars in the past
the under cup and the motor leads to the sensor ****llo engine oil? c'? a three-wire cable "cut" where is the sensor for the under cup...
the car ? was pi? times controlled and the engine has no problems, **** llo oil in particular ? ok...
I tried even to remove the error from the map of the ecu but the light remains...
advice?
thanks in advance!

[sportknight]

you have to find the right value of resistor to connect the 3 wires to not to turn on the light,you probably will have changed the cup, or worse still the whole of the engine, and then the sensor was not in pi and have not been able to delete it

[Rebound]

I had thought too, but I don't have the ir? clue of the value and use it..***** and do I connect it to the 3 wires?
I don't have to connect only between the positive and the signal that arrives at the dial?
or between the mass and the signal?

[gick]

you have to look for a cup with the sensor or the sensor itself and aim for the impedance in ohms, which develops, so are 3 wires then you have a positive and a ground and a signal, search on the internet or in a database, and then try to apply a resistance.

[freddyecu]

The cup has the bore X of the sensor or not?

[dangy]

considering that this is a very fair response