you can when you have time, tell me what are these limiters???
the erg, I've already closed the map, mass air flow sensor on the basis of what should be change???
however, I did another log at idle rpm(850 rpm and 450mg air) and I like the iq 4mg/i; if I go in my map smokes I take the column of the 350mm3(would be 452mg I did 350*weight spec.air) at 800 rpm I as the value 25mm3 that if I mg become 21,25....
is there something that I did not go back......
I have discovered...
Injected it in myself more diesel than that calculated map smoke because in the torque limiter of the values I had calculated in mm3 instead are mg....
07822c.rarthe damos that I'm using I is a 147, however, the address 07822c of my map is this that I am attaching....
if could you explain to me what would I thank you in advance.
I am a beginner also and I interpret the map it is difficult for me...also the other addresses I found them all but if you can give me a small description would you help me.....
IS the initial amount base map M_fuel = f ( N , T_water ) ( 10x8 )
1 * 10E - 2 (motor speed conversion , temperature conversion) / mm ^ 3
grad C
this is the translation of the description using ****** translator.
hello
This map 07822c is a map for the amount of diesel in the start-up phase
Could you attach your damos saw that in my lack of descriptions maps pleaseOriginally Written by joker01
then the map will not tap???
I am attaching the damos I have translated all the addresses but I did not understand much ,if once find the addresses of what to match on damos, and I want to help you thank you!!!
hello!!
WinOLS (Damos Alfa 147 1.9 JTD (Original) - ).rar
No't need to touch it only affects l starter no increase in the power
Ok.............
considering that this is a very fair response
Write permission
Quote