the elimination of the start&stop from the map or not ?

[mate89]

for ford fiesta 2009 you can?

[V.V.]

Also for EDC16C34, tested!

[michele30]

conditions of failure to stop motor

With the active device, the engine does not stop in the event of:
- the engine is still cold (sensor signal of the motor temperature is less than about 40?C);
- battery is not sufficiently charged (state of charge is below 75%), or, if it is detected malfunction of the sensor and the battery charge detected;
- a depression in the dell?braking system, detected from?suitable sensor, for example as a result of repeated pressure on the brake pedal;
- regeneration of the particulate filter in the course (only for Diesel engines with DPF);
- malfunction of the voltage stabilizer
- rear window defroster activated (assumes the willingness? dell?user to make the demisting of the crystals, for which ? should the engine to remain turned on in order to make available the hot air and/or conditioning)
- windscreen wipers working at maximum speed? for pi? 4 sec (it is supposed that in this condition there are adverse weather conditions as a result of which ? it is desirable to have the maximum driving comfort);
- driver door is not closed;
- safety belt-driver not connected;
- reverse gear engaged (in order not to prejudice the guidabilit? during parking manoeuvres);
- with automatic climate control, if it has not been yet reached an adequate ****llo thermal comfort (temperature, air conditioner set up by the customer with the difference greater than 4?C compared to the temperature inside dell?the passenger compartment), or enabling the MAX-DEF;
- malfunction detected on some of the sensors or systems
- in the first period d?use, for initialization of the system.
- air temperature is particularly cold, if the expected l?a specific indication.
In the cases above ? visible an informational message on the display and, where applicable, the flashing of the indicator light on the instrument panel.

[franco-elettr]

I have a mito 1.3 2012 you can delete?
I mean the start and stop

[franco-elettr]

I have a mito 1.3 2012 you can delete the start and stop

[maku1977]

with the latest version of multiecuscan you can disable

[maku1977]

I think from 2.5 onwards