Map 8x6 0621AE Y-axis temperature of water from -10 to 100 ?C, X-axis Rpm from 750 to 4688 reversed. Not to serve? having regard to the BP of the temp but surely ? a map rail
Map 8x6 0621AE Y-axis temperature of water from -10 to 100 ?C, X-axis Rpm from 750 to 4688 reversed. Not to serve? having regard to the BP of the temp but surely ? a map rail
8x12 0677C8 y-axis IQ X-axis RPM is not reversed. What do you think?
0677CB I think it is the y-axis NM x-axis RPM, but let's talk about the map for a time, otherwise we do not understand anything.
Let's start from this, the shape of the curves you would not say rail pressure even if the values look like them.
hi I would like to ask if cn map mod lim rail lifted up, the machine has good performance, and if the rail is ? actually lifted up....why? for me, besides giving only the diesel fuel does not ? been done.....the times are calculated for 65mm3 then....I would like to know if ? been tested
Today I tried to install a map with the limiters rail already? known pi? 2 unknown that I moddato I (the value of the Z axis seem to be the values of the rail), I sat as co-pilot of my friend and with a diagnosis autocom (very thin for this car) I read a value of 150 Mpa = 1500 bar, then the pressure objective of the map rail ? been reached. The problem is that after 3000 rpm it flashes the warning light car with key English seghettando slightly. I do not know if ? fault limiters the rail (if all those of the screen that I enclose are) or if as I'm thinking of can? be the fault of the map rail true moddata evil (for example I am thinking of trying to lower of 50 bar and curves on the bp 3000 rpm and pull straight up to 1600 by removing the step that c'? series on the last laps)
Screen Rail.rar
dariuccio I tried it on the car as you can see from the screen attached with this map, moddata in the curves that had 1550 as the max value alzandoli of 100 points, but the flashing of the indicator lamp does not light ? gone...Originally Written by dariuccio
068596 cos'?? why? have you touched? according to me, no ? what we are looking for. the third bit I don't know nothing but gi? that the pressure gets to 1500 I think
not needed
the other maps are unknown that you have said, I've never seen any n? modify n? talk about it without a damos I have the idea that it is impossible to know
the only map that I have seen touched some of the time but I have no information ? address 065DCC, but I have seen that in some of the driver is recognized in the place of one of the usual so it may have been a mistake thinking that it was something else
however, it also happens to me the same thing about the pressure, I have to still do a log for? it would appear that when you exceed the 1450 bar start to blink
in theory it should go up with the two bits, and the various limiters, on a point of a friend of mine that I did on the fly I seemed to ignite anything, while on the run with the same changes, problems
maybe the opel c'? something more? that limits
I looked 065DCC I can't imagine values so low, maybe it was the maf or map but I don't think.
map and 067436 what do you think?
at x rpm, for sure, in y should be a pair, the values of z in reality? do not resemble nothing known, or have a conversion factor that we do not know
Quote
