problems read ecu id grande punto 1.3 mjet 75hp

[alessio105]

hi guys tonight with my mpps v13 clone I wanted to read the identity? the ecu grande punto 1.3 75 year 2007 so that you can contact the support to give a number, hw and sw, and to prepare the map, but it makes me a bad joke...I connect everything correctly cable obd including I turn it on the picture I select grande punto 1.3 etc etc I click on ecu id and tells me 'ecu not found' and, therefore, does not give me the info hw and sw... and yet I knew that these, at least, at least you can write how can I do that?? the mpps as it may be a clone, I've always used the bosch edc 16 and never a problem, this is the first marelli...careful your advice and opinions, thanks

[passione motori]

Hello, are you sure that the face ecu id on the can line your tool?

[francescosparco]

test with a diagnosis and see what is

[alessio105]

ok thanks francesco and now try to enter with the diagnosis and will update

[ema74]

otherwise, you can read the nameplate on the outside of the unit which hw and sw is

[passione motori]

otherwise, you can read the nameplate on the outside of the unit which hw and sw is

and is often not with the content of the ecu.....

[alex68]

pu? have on board a spansion happened to me and then only with the bdm.

[max75]

it seems strange I never had a problem with at least the id should take the test with another protocol....

[Alessandro sp]

guys I was on my grande punto 1.3 75 hp nn I could write, or to get me to give it another file ori and the mapped and then loaded