exclusion egr bravo 2.0mjet in diganosi value to 128%

[legendaryslave]

I seem to recall that some have solved by removing the plug and inserting a resistor (I can not say by how much).

But with the resistance after a while it generates the dtc if the valve is not working should remove the dtc, if not c'? the strategy of recovery

[cinqueturbo]

I seem to recall that some have solved by removing the plug and inserting a resistor (I can not say by how much).

39 OHM 5W.. two or three days f? or resolved with a LANCIA DELTA 1,6 Mjet 120cv that I had closed by the ECU but the electrical part was faulty..

[SandroMarciano]

Alternatively, you can just disconnect from the map, just move the error threshold...

[max75]

I seem to recall that some have solved by removing the plug and inserting a resistor (I can not say by how much).

thanks....

[max75]

Alternatively, you can just disconnect from the map, just move the error threshold...

the problem ? get to know the area!!!

[blitz3r]

in the case of EGR to 128% in spite of the closure with the "2 panettone", I'm reporting that ? only a problem for software multiecuscan, tested it today with 2 other instruments (marelli and Delphi) and on both the egr is open at 0%, check the egr disabled and the target position and the actual to 0 mm in any running condition.

[ake85]

try this......

closed perfectly good