hi
to be able to scodificare a control unit Siemens sirius 32, the file that is read in serial + boot mode must be decoded before being processed or not?
I know that if you read the 29f400 dissaldandola then you decode the file before sending it, but I don't know if it is the same with the file that is read in boot mode.
once you read it, open it and see if ? in the clear, I believe that it is encoded.
ugo ---- president A.E.P.
depends on with which to open the file, winols tells you if and encoded. anyway, as it says in ugoboss open it and see if the maps are in the clear , but if not, you have to decode it .
I use ecm.
I think I read it with the cock 1260 in boot mode
I dissaldo on that ecu. I know tastes
I have always unsoldered, and also because I have never been able to read the ecu in the boot.
ugo ---- president A.E.P.
the same thing always unsoldered...........
If the laws in the boot, the file should not be encoded
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
with gallo v53 you can read and write in boot
write FF 4000 to 8000 in flash
cut inmo line pin 58
Quote
