It does not matter if they are chinese..the procedure is always the same..follow the advice of ugoboss
It does not matter if they are chinese..the procedure is always the same..follow the advice of ugoboss
in fact, now I have learned a great ugoboss...I can even cut them and connect the two eib terminals...short acquister? a bosch and marelli and make? my first readings and the counter and then you do? know thanks
I understand very well your question, you use and feed as the original products.Originally Written by ake85
ugo ---- president A.E.P.
Hello ugoboss I'm reading at the desk marelli NEVERTHELESS 6JF I unsoldered the resistor and according to the guide of the cock the pin in a total of 12 but only 10 are used for reading...my e xxx marelli included in the template has 12 needles welded them...do I have to unsolder the two true?thanks
Don't have to unsolder anything if loschedino and' marelli pay attention only to the cable that the 12v from the right point
use with all 12 of the needle retracts, if the laws in the bdm with the cock you have to put the adapter without powering it, the power supplies by directly on the comb of the control unit.
ugo ---- president A.E.P.
thanks for the replies...the guide says to use only 10 pitches, and not 12, but the coupon marelli has 12 needles...ok poggio the e xxx with 12 needles on the pitch and see if it reads...ok ugoboss
I put flat bdm adapter, CMD, flat e xxx marelli and food 12 volt...let's hope so...for the first time, I have already? unsoldered the resistor in a moment I'll go ahead
the voltage is 12.9, but it says error micro not supported...I have connected the flat cable adapter flat and e xxx on pitches...then I connected the obd socket with the wires to the corresponding pins but not the law...
Strange controls the contacts of the e xxx ..the verse of the adapter....recheck all the steps to good
Write permission
Quote