The reading control unit subaru sti 2002

[Cimo]

Good evening,
I have recently bought kess v2 clone and I have already read the different units, just yesterday a friend asked me to read the ecu of his subaru STI 2002 2.0. 265cv, I will begin with the reading and at some point I'd remove the contact and then it is written: error alarm. Could you tell me what is the problem? Thanks a lot

[msport (exil77grande)]

you're following the manual where you are asked to insert a jumper in a connector?

[CLAUDIO.]

you need to connect the two connectors, green, under the dashboard , and then on the basis of a year c and a', as it says in the links mssport the jumper on the white connector

[scican25]

Good evening,
I have recently bought kess v2 clone and I have already read the different units, just yesterday a friend asked me to read the ecu of his subaru STI 2002 2.0. 265cv, I will begin with the reading and at some point I'd remove the contact and then it is written: error alarm. Could you tell me what is the problem? Thanks a lot

when the kess gives you the error .. and because I can't read the encoding data unit .. you can do the test to change speed in voice setup
or use the program in the subaru rom raider

[Gianpy80]

the ecu only read with the openport, and the kess in the list but not law, at least the clones..

[msport (exil77grande)]

the ecu only read with the openport, and the kess in the list but not law, at least the clones..

fortunately you have specified (CLONE) because we have read a dozen with the kessv2 without problems, but of course we talk about tools official.

[Cimo]

what would be the manual to follow? with the connectors to connect the bridge to do?

[msport (exil77grande)]

what would be the manual to follow? with the connectors to connect the bridge to do?

the kess tells you how to connect to be able to read the car.

[Cimo]

I honestly do not know how to do, someone can send me the photos of the procedure??