hi to all a drive a friend's bmw 318d year 2011 edc17c with tricore st797non part but it is connected in diagnos with autocom and error 4b94e not ce to to get it to start after it opened I tried to put in motion but no and game more on the ecu there are no visible signs of damage
before you opened the ecu to read in the boot complete I have also made reading the obd
I enclose a file read control
tell me the exact procedure that you used to read and write. For the case when you removed the ecu you switched the ecu removed?
the file that is read in the serial is not absolutely good, when you have these symptoms, it is usually the ecu that is missed.
ugo ---- president A.E.P.
thank you all for your collaboration and interest offered
however I solved
looking at the pcb dell ecu with attention I noticed a micro smd resistor that was moved by disrupting the function of the module and the injectors I have suffered a bit but I managed to fix and the car is allocated
as I explained I have only read a serial port and boot with fgtech v53 with procedure tprot password
I would like to open the read file in the boot with what software should I open it??
hello there are various programs you could use for example: ecm...
you use ecm titanium 161 but the driver is not ec, was wondering if cenera someone compatible between the ones available
it is too new to this ecu / ecm 1.61 you have to try with winols if you have the damos
winols is there but not the damos
and then there's nothing you can do
Quote
