Error P601 NEVERTHELESS, 6F3 Scodificata

[pippo65]

Hello guys,I made scodifica total on fasch and partial on the eeprom,the machine goes without problems but I get engine failure.
I checked with diagnosis, and gives me this error: P601 Ecu faulty(Eeprom)
What can it be?
Thanks.

[cinqueturbo]

You have confused the ECU like you on the other hand...

What you need to get a Total or a Partial on this ECU???

if you need a Partial Work on the E2Prom to Stop..

if you need a Total Work on the Flash Stop..

[pippo65]

You have confused the ECU like you on the other hand...

What you need to get a Total or a Partial on this ECU???

if you need a Partial Work on the E2Prom to Stop..

if you need a Total Work on the Flash Stop..

Hello cinqueturbo,I've definitely made a bit of confusion,but can you explain to me when you have a total or a partial with this type of ecu?
And which software is best to use?
Thanks.

[cinqueturbo]

This ECU uses it only on this car? Partial
This ECU you use it on different cars when it happens? Total

The Software will count as the stars in the sky..
Which will you have available?

[pippo65]

This ECU uses it only on this car? Partial
This ECU you use it on different cars when it happens? Total

The Software will count as the stars in the sky..
Which will you have available?

You use it only on my car,and then partial.
As software I Meucci,Time and immodec 3.2. I'm fine with Meucci because it calculates also the chek,can you go?
Then the error that I find in the diagnosis, the more light the engine turned on, it may be because I made the scodifica is to flash the eeprom?

[carlo abarth]

or are you on a or you on other that or work on flash or on e2p!!!

[pippo65]

or are you on a or you on other that or work on flash or on e2p!!!

I understand,thanks for the advice.
Hello.

[pippo65]

If you have to use only on your car remove the total on the flash, and make only the part of the eeprom.
That error will appears if you edit something by hand, in the eeprom, or because the file the virgin who gave you the program is not 100% with the sw version of your ecu, the diagnosis drop him a line the codes of the injectors, do a reset parameters autoadattativi, and give us a few km, you'll see that the error disappears.

If you do not were to disappear, I'll explain how to remove it completely from the ecu.

Great Matthew!!
can you tell me if with Elm 327 more multiecuscan can't encode the injectors?

[pippo65]

You should do this, but 100% not I can guarantee you that, once I tried on a doblò and was not going to end well, I'll write them directly with the examiner.

Yesterday evening I watched on Ecuscan 2.2,but I have not found the Encoding entry in the injectors,can you tell me where to find it?

[pippo65]

Select your drive, then select the control engine and Marelli 6f3, once connected, go into adjustments and find the items classification the injectors, leggiteli before your ecu ori and segnateli and then enter them in the virgin.

Hello Matthew,as soon as I can I try and let you know.
Thanks.