problem with kess v2

[vittoriopl]

hi to all
today trying to update my kess from 3.099 to 4.036 something went wrong and or all protocols of grey.
by connecting the jlink gives me connection error cpu not supported.
does anyone know how to fix it?
there someone that can repair it?
thanks to all

[passione motori]

Hello, with the old fw 3.xxx connected it in jlink? a maximum of buy a new processor and go to a technician and you do replace.......

[vittoriopl]

Hello I don't know if the first connects because I have not experienced.
Anyway thanks and merry christmas

[Fabiuz]

Excuse, and how you have upgraded from 3.099 * 4.036 without the jlink??
The file to write is called K10033818.bin
You wrote this file with the segger???
Have you done the update protocols with the 2.08 DE?

[eng.majdi86]

how i can update kess v2 ?

[walter_ie]

It happened to me!!! Then, I've thrown away the kess... Anyway, they say to rewrite the SD card to the inside with the new protocols that give you along with the update. First, however, formattala in fat and should ridarti protocols

[Fabiuz]

But at the time when you start up the their computers 2.08 of the update protocols, and you find yourself at the end with fw 4.036 and protocols for cars bikes etc.. active. NOT in grey.
Then format and write the SD card ok, but will you get there already with the kess funzionanate and vehicles selectable

[amen]

Good evening, same problem, in my case, I can select the section to drive, but then when I choose the car does not make me click on ok. I tried a tool to reset the token, and update of the protocols, everything is successful but then I open the software again and I am in front of the problem. Do you have ideas?

[Fabiuz]

Try to use it with their computers 2.06 Full, or 1.89.
If you select the drive, but then it makes you press ok, it should just fix the SD card.
If not successful, you have to change the cpu.

[amen]

I changed sd card and put the same files of the old,nothing to do.