Recovery ECU Siemens

[flamingsn3Ak3r]

Hi to all,

today I tried my mapping on a Range Rover with
Siemens SID 203, but the car goes into recovery when it passes the pressure of the turbo
the original, that is, 1.0 BAR, the almost when you are at full throttle.
In the map I also changed the pressure limiter in game of 600 points for the avoidance of doubt
but the problem persists.
The pressure reaches 1.1-1.2 BAR from the diagnosis in drive mode and in sport mode also has reached 1.3-1.4.
Being a person that does not crush on the accelerator pressure, provided that high is fine with me as well, then however, if you advise me
to reduce it I will.
According to you what is due to all of this?
The machine, however, besides the recovery goes very well, pulls up and does not smoke.

All the Data are inside the archive, which I enclose.

Greetings.
_MAPPA_SIEMENS_SID_203_RECOVERY.rar

[flamingsn3Ak3r]

UP!!!

Do you think I overdid it with the injection split or
with the injection correction?

Greetings

[flamingsn3Ak3r]

Hi,

you can close I fixed that I was able to do the mapping, do not go to recovery

Greetings!