driver problem, and the recognition maps ECMtitanium that Ecm2001

[Anubi]

good evening guys, today after the first reading with galletto 1260 from the OBD, I go to load the file first on ecm2001 v6.2 and I lose about an hour to find me the url of the map to close the egr. Without having achieved success, launching me from the pc to the virtual box and I start ecm titanium with the similar issue, I can't find the address, map, egr, and now even the appropriate driver. The question that springs to mind ? or I've done something wrong, having pi? times read both in the forum and on ****** the egr on the marelli (fiat punto mk2b 1.3 mjt 70cv) is located at the address 067C4A in 16bit or precedento owner of my car did some editing, being a beginner and still in difficulty? understand that the map I have before I ask you kindly if you can give a look to my attached file (read flash entire).

Fiat punto 1.3 mjt 70cv Marelli Multijet MJD6JFHW01A
Num SW:1092P159
Dis FIAT: 51757344

flash_intera.rar

[Errecinque]

To you your file with the EGR OFF. not all have the same address

INTERA.rar

[Anubi]

To you your file with the EGR OFF. not all have the same address

INTERA.rar

thanks a lot errecinque, since I can not download it, you can have the courtesy to explain to me how to find the addresses?

[Errecinque]

Ops!! I have not made the case that you can not download the attachments, I'm sorry.

[Errecinque]

you have the file corresponding to the guide where they address 067C4A ?

[Anubi]

you have the file corresponding to the guide where they address 067C4A ?

yes, I have a couple of .ori downloaded from ****** to do the tests.

[Errecinque]

On your map is located at the address 067C4A, then you have to find a file gold panda 70cv where at this address you can find the value 14252. (2d view) 16-bit motorola), At that point you make a screen of that portion of the map (or open 2 times ecm) and go find them on your map to the portion with the same curves and l? you will find the bit at 14252 up-to-47506. The council do not load any driver in the ecm along with the map that you've read from your car works only in 2d, why? your file does not appear to gold and when you go to save the file to the ecm you change the bits that don't make you go to start the car. compare two files in 2d and clicking the button "next difference " must give you only the difference of the bit to the egr and nothing else. Goodnight see you tomorrow if you need

[Anubi]

Thanks 1.000 enrrecinque, one last thing, being that the egr ? at the same address than the panda 70cv, the same is true for the other maps?

[ugoboss]

I can confirm that your file is not ? the original, the egr you have to 062700, and I don't recommend you write it with the galletto 1260, your ? a MJD6JFHW01A and these are unpalatable , the machine should not be in the bike once written.

[Anubi]

Egr found to 062702, I read the message shortly after I started to write it...fingers crossed