guys good morning I am trying to do a boot of this ecu,I made all the connections, or hold free and so far everything is ok,I read all the bachup and I get this error:START READING error sending key error unlock password read - try tool tricore password tprot v08....in practice, I read only the flash,if I wrong I something I did read nothing!!!!what do you think????? I do not or experience on these ecu....
with what you're reading, gallo2?, if you look in the documents folder contained in fgtech that ? explained something related to the tprot I believe that it is a protection antituning, then waiting for some info from the pi? experts
possibly you do not have the password for the tprot
There are no fast cars... But only foot heavy!!!!:cool::cool:
hello guys, thank you!could you explain I don't understand!!how do I get the password for the tprot???on the gallo v53, there is a function but I do not do it!!!!
I have to say that I've never done it, and then no, of course I can teach you for? I think I have read somewhere that the function that you say that c'? in the cock should just detect the password, and then you can then read the ecu for this I told you to wait for the experts, why? they definitely know how to explain it betterOriginally Written by alfetta80
the function that is located in the cock of the tprot I made it, but it fails,I don't know if I'm wrong, but there is a little mistake that I select the trpot passwoerd then, I made the ecu data and does not!!!boooo!!s, and someone more knowledgeable can give me a little help...thanks again!!!
Hello
Read the document for the tricore, and see the procedure for vag pass tprot read, you have to trade one cable pin-out, or to do with the ecu montatta in the car.
the wires them or exchanged the green ones with the red ones and or removed the grey wire, data is now the ecu can't do it but then it makes me do most anything like that?in practice, I should read the file as it works??what is the exact procedure??
I went to read the pdf and I says to swap the green wires with the red ones use the driver tprot v8/10 but then return to try again in the boot mode back to the conditions of the first (and then I think again with the green wires + and the gray boot with resistance) and if it still does not work, try the driver tprot with the control unit mounted on the machine (they mean by serial?)
hello sisco but use the driver that is what you meant to me on the tprot to do it in a data-only ecu I see nothing else
Write permission
Quote