I should scodificare an ecu edc15c2 citroen picasso only one plug, taken from the demoman. How should I act??
I think I have figured out that they only make in flash, total...
His ? route, can I recover the old eeprom, whereas the number of different hardware?? Although in vista are the same...
You as a solution only the total on the Flash..
or read the contents of the Eeprom and write it in the new one, or move it.
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
By moving the eprom is not part...
Azz..Originally Written by blackwolf76
mail reading..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
you have to put it with the same number bosch otherwise nada and then walk to both the content of the 2p+29f400 in the new one don't you go and wrap in total for the time being
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
Absolutely right..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
With the same number I found... I got another same type with a different number. Screwed me over that I didn't know is what the incompatibilit?, I thought it was as a group, fiat...
I know that at this point, do I have to do the total... ? can read it in the boot??
PS: with the tl866 I can't seem to write data to the eeprom changed on this and gives me the error address, while if you rewrite the file there are no problems....
But in the Boot you can still read the old ECU? or totally gone?
you may also transfer the SW..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Probably will be? I that am nerd co is in the car...
The original unit has some issue that makes them not recognize the accelerator pedal, and different sensor on the engine. I managed to? to read both the eeprom and the flash-to-tour without any problem. Despite the eeprom can also put them on the bike.
The other demolition instead I wasn't able to read the flash in any way, not even on the bench by removing the eeprom to the difference of the other, and the car in spite of everything fails to boot, what should I do if the eprom is missing, also the mounting of the other.
According to me I need something other ecu...
try to move the flash's? you are equipped..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Write permission
Quote