bosch m1.5.5 alfa gtv 061/386

[skizzo93]

hello all, can you please tell me something about this mod file??? car parts mount the final ss,filter bicones,re-profiling is made and polishing the throttle body,the tube straight suction gta,the first central ****** and soon kat 200 cell....I would be able thank you I accept all the advice for a newbie like me (only 1 year and a half that I am interested in this field) are all gold....thanks

ori-mod gtv 061-386.rar

[rimec]

Same problem...you have you solved it?

[munro]

do the mappings to cazzum? if you do not mount a wide band and check your AFR you will find yourself with a nice hole in a piston,the possibility? far from remote, seen that it speaks of the ecu and motrizzazioni petrol....some things can't be done sitting in front of a pc writing in a forum...with all due respect to the forum and its users...but you have to put the seat in the car and went to monitor the vital parameters of an engine and then contact them to change reviewing the above to see if ? everything as you expect it should go....
you can map the fuel table....according to me.. if you are so experienced to know exactly how to do it without logging or monitoring anything...bh? then, according to me, a waste of time writing in a forum asking for advice...

[rimec]

hello
we're just learning ? somewhere you have to start. therefore, quoto what you write, only that in this case, it takes many adjustments to the mapping, then every time you need to program a new eprom and insert it into the ecu with the modified map to the place of the old, since these eproms are programmable via the serial port. it would be useful to an emulator but is......can you recommend?

[munro]

do a search on ******....c'? they are different all very good, just don't take "cineserie" however, for me the best are the innovate,plx,ostrich 2.0 and a power commander ? English then you can count on the support of the house...

[munro]

there would also be the tool alientech called the "device" that has a cost aboradabile with a data logger that is valid and that you can? implement also knock sensor to fine tune the ignition advance that uses a wide band bosch very reliable and accurate in reading...

[rimec]

sorry, I badly expressed, these indicate meter stecchiometrici, and they are ok, I was referring to the modification of the mapping. Can you recommend some emulator?

[skizzo93]

Munro thank you for your reply and I want to clarify one thing:
I don't seem to have said that non-control l afr after you have loaded a mod file. Control the afr via obd doing several tests, and creating charts and then riverdermeli ( since the value afr and important load to full load, and I can't see it on the time of continuous operation).... however, the discussion was intended (who wanted to) to give me tips x the map in general, and especially perhaps for down payments...then you should not be so biased.if you want to and you like give me some advice on the mod file thanks

[skizzo93]

Rimec this ecu is safely in serial by programmers obd and load the map it takes you and no 2 minutes. .. c), and only a few tricks to do how to enable programming via the pin and compress in bcb the mod file before uploading it...so there is no need to make it to the tour even why? not easy to put it in the boot. Only drawback of this ecu
? in serial you can only write and not read, but this is not important.hello

[rimec]

Thanks Skizzo93
I have gi? made some modifications to the tour, the problem ? that ? difficult to understand how change, in particular the advance seen that have changed a lot all of the geometries. I did not understand how to connect with the instrument, gallo, cmd, etc, to the diagnostic socket ( what ? the fiat 3-pin) to load the map mod. The compression bcb how to do it?
sorry if I seem stupid but the course I did, but then practically there are many variables to know