the problem ? this I connect everything I have been reading the data ? ok then do read flash and nothing, after a while, I create a log, but I can't read.
and gi? happened to someone?
some council.
thanks.
edc 15 c7.jpg
the problem ? this I connect everything I have been reading the data ? ok then do read flash and nothing, after a while, I create a log, but I can't read.
and gi? happened to someone?
some council.
thanks.
edc 15 c7.jpg
The procedure ? the following:
colleagues of everything, including the mass, insert the power supply and unplugging the mass in the pin boot, and read more
The patience and virtue of the strong..
as you say I have not tried,but I have heard that you must unsolder the 95P08, and after doing the procedure
You have to unsolder the e2prom why? c'? the block of code, or dissaldi and put it all to ff within the e2prom and then the risaldi and maintain reading, as I have explained to you priama
The patience and virtue of the strong..
I do not understand why not ? written in the dell folder fg this procedure.
Write permission
Quote