Opinion the Map Alfa Mito, 1,6 JTDM 16V 120CV EDC16C39

[cinqueturbo]

Good day friends..
tonight I was struggling with the DPF and EGR to this car, and I have tried to take a step mod
would you give me your opinion and advice?..
Thanks..
The ori can be found here: http://www.professionalchiptuning.ne...4&d=1394620224

and here the step mod with FAP:

[Backgroop]

The map does not ? bad it is for you can? get pi?, the only thing that I would do are the torque limiters and the rail pressure in order to avoid vibrations of the flywheel at low reggimi with higher gears, the exclusion of the Egr valve ? ok the Dpf with which software have you tried? give it a try and see how it goes

[cinqueturbo]

The map does not ? bad it is for you can? get pi?, the only thing that I would do are the torque limiters and the rail pressure in order to avoid vibrations of the flywheel at low reggimi with higher gears, the exclusion of the Egr valve ? ok the Dpf with which software have you tried? give it a try and see how it goes

Thanks Backgroop ready for action..
Mmm? lim,torque and pressure rail?
them rivedr? to better understand..
The FAP of the hand-made with ideas from the various previous files (GS)..
for more tips and riciami on the improvement of your friends are here..

[ugoboss]

the limiter it would start to change a bit after, and I would give a little more to the pedal, and especially to the turbo.

[cinqueturbo]

Or seen the points that I referred to.. so just to be clear?
Out of the driver can you tell me something?
the cio? dinners need to make it move or just the driver?

[ake85]

[QUOTE=cinqueturbo;86212]Or seen the points that I referred to.. so just to be clear?
Out of the driver can you tell me something?
the cio? dinners need to make it move or just the driver?[/QUO
In my opinion the couple ? changed bad I would give more? and, above all, turns ir? high not need starting from 1000 rpm ( and then if a single couple I can I change it always in 2d )...a limiter rail ? wrong value too low if by 322 points to the rail pressure, you can't give 322 points also to the limiter...you are opening times of the injector should be a good percentage!

[ducati83]

I think you need is the maps of the driver ... or rather, I have not found special maps that had changes out of driver, and it maps an overboost...

[Backgroop]

If the car has no special modifications such as turbo plus and the other just the maps that suggests the ecm, if you want to do something special and want to lose a bit of time if you follow well the files are there other limiters to change that ecm does not indicate.

[ducati83]

type limiters IQ? right?

[Backgroop]

type limiters IQ? right?

C'? a discussion of the breakfast where you can? draw http://www.professionalchiptuning.ne...ht=impariamola