How to Make it More Sensitive to The Accelerator Pedal Edc 15C2

[CHIP TUNNING]

Hello and thanks in advance to all those who respond, I remapped a Scudo 2.0 jtd EDC 15C2 taking values from some files that I have sold the set to the rooster, and sincerely means it's so much better than the two maps previously made by two experts, which had increased the rail pressure and turbo pressure having as a result the engine at low revs was beating like crazy, however the mapping that I have done with values near a little here and a little goes quite well, I would like to solorendere a little more? ready when you touch the accelerator.



Anyway, thanks to all.

[SandroMarciano]

To increase the sensitivity? of the pedal you can increase the map as much as you want (to your taste).

That said I'll warn you that plain rip offs without knowing what you're doing ? dangerous...

[CHIP TUNNING]

Hello sam and thank you for your answer but the problem ? this file open with ECM titanium does not give me the map accelerator pedal, but I get the following maps
INJECTION CHOKED (2)
INJECTION CHOKED (boostxrpm) map 1
INJECTION CHOKED (boostxrpm) map 2
INJECTION CORRECTION
INJECTION PHASE
and then the other maps that turbo and limiters various
Which of these should I tap?

[SandroMarciano]

I do not know the ecm, perhaps injection correction, otherwise if I linki file ori you looking for the address of the map

[CHIP TUNNING]

I don't know if from User, the beginner can I attach the FILE?
That you tell me to do it attach?

[SandroMarciano]

yes, but first checks to see if ? gi? present or not in the designated area of the original files, in case you attach the l? and then here you put the link.

[CHIP TUNNING]

Then sandro I found on the bulletin board that you said the same file of my inserted from the NOX 30/01/14 with the name
shield 2000jtd 110cv
edc15c2
0281010591
1037353871
Hw and sw are identical, you can see on this, thank you in advance but I ask you the courtesy of pointing me to the map decimal why? sonocapce only on those on the other are an emeritus ingnorante.
Hello and thanks

However, I thank you infinitely, you are the first one that is giving me some response, are also registered in another forum, but it seems that nobody is willing to give advice
Thanks

[SandroMarciano]

*68564 *685e8 *78564 *785e8
These are the addresses of the maps relative to the pedal.

[CHIP TUNNING]

Sandro, thank you for your help but these addresses on ecm titanium does not exist, and apart from that I don't know put his hand in hex but only in the numerical tables, the ones where you've got the two axes, the vertical gon tours, and the horizontal with the load.

[chiptuning.cro]

Sandro, thank you for your help but these addresses on ecm titanium does not exist, and apart from that I don't know put his hand in hex but only in the numerical tables, the ones where you've got the two axes, the vertical gon tours, and the horizontal with the load.

Usually, but not always, in the ECM, map the pedal, and' "enrichment and acceleration"...