help before scodifica sirius 32n

[mar21]

I have to say I am a beginner so any advice ? well-pleasing, then I have to scodificare a clio 1200 8 v with control unit sirius 32n 110013800, I read with gqx4 the 29f200bb then I did with immodec
cut the wire 58 of the line immo but the machine doesn't start, the first attempt should not be the starter alert while on the second attempt, the motor goes but the machine is no ,and the red led remains solid . Aiutoooo
thanks

[legendaryslave]

you are decoded and re-encoded the file before sending it to the soft

[angelo]

I have to say that I know that there is an emulator in this unit, however, try with this:

[legendaryslave]

the eye that slammed the muzzle if the reading was done from the 29f200 with the programmer, the file must be decoded siemens the past in the soft recalculated the cks and recoded to be written directly in the flasks

[mar21]

guys I'm sorry but with what decodifico siemens the file I gqx4 and ecm titanium, and how do you??????
ditto with the cks????
thanks again

[faberecu]

Immodecodind offers you a different file that processes the your on the clio has made a mess. You need to edit the file or post to read and immo dec

[sno74]

I hate to say this if the file ? read from flash with the programmer you have to decripatare the file and do the steps that was written before otherwise the car is not part.........

[mecdoc]

ecm-tools-encodings

[sno74]

I have made a I with ecm the steps are these....

[Elettrico]

I agree!!