Vw Polo 12 tdi code anom. 15514

[ecutano]

Hello Raga , are struggling with a VW Polo 2011 12 tdi that is not a party , as a fault code read with the Launch of 15514 , can you tell me what is equivalent ?

[sno74]

if you do not have any specification or description may not recognize it and tells you this error you do not have another diagnostic tool to test....

[ecutano]

if you do not have any specification or description may not recognize it and tells you this error you do not have another diagnostic tool to test....

I tried with Texa , but in the OBD scantool , and there are no errors , the only tool that detects the error, and the Launch

[rego88]

the problem ? happened in the circumstance of supply for the case??? have you tried to remove the pump from the tank and see with a stack if in the bottom of the tank c'? the filings??
a friend I know ? 've a similar problem.... the car after the rifornimeto you ? off, and wanted to know more of starting, in the tank filing of the pump changed under warranty the whole system injection in the volkswagen, ditto.... he didn't.... in the end they resolved with the vas, by connecting the on-line diagnosis in connection with the engineers of vw and have solved the problem.... never detected.....
it starts by seeing if c'? the filing

[ecutano]

the problem ? happened in the circumstance of supply for the case??? have you tried to remove the pump from the tank and see with a stack if in the bottom of the tank c'? the filings??
a friend I know ? 've a similar problem.... the car after the rifornimeto you ? off, and wanted to know more of starting, in the tank filing of the pump changed under warranty the whole system injection in the volkswagen, ditto.... he didn't.... in the end they resolved with the vas, by connecting the on-line diagnosis in connection with the engineers of vw and have solved the problem.... never detected.....
it starts by seeing if c'? the filing

The fuel pump runs , I have not seen if there are any filings in the tank, but I will say that the engine control unit does not command the regulator on the high pressure pump so I have no pressure in the rail , the regulator current does not reach , I only have a 12 volts to the switch-off of the picture for a few seconds.